|
|
|||||
| From | Message |
| larry davidge 10/31/2006 7:21:02 AM |
 Subject:
Nu-Lustre 55Message: Is it possible to remove the bubbles once tne material has set? Can I sand it and then add a top coat that will look clear and smooth or is it possible to heat the set material and get it flowing? Thanks for any advice |
| Mark 10/31/2006 5:26:20 PM |
RE: Nu-Lustre 55 Message: Once the material has set (after 2 to 4 hours), the bubbles can no longer be removed from the finish. However, are you refering to bubbles in the finish, or is the finish not smooth? You can add another coat of Nu-Lustre-55....no sanding is required. |
Post a reply to this message:
  |